CHP Max5000 Power Supply—CHP Max5000 isolated, load-sharing, redundant power supplies are available with either auto-sensing (110 to 220V) AC or DC (–72 to–36VDC) input. One power supply supports a completely loaded chassis, while two offer power redundancy eliminating service interruption if one power supply or line-in feed service fails. CHP power supplies are located on the far right side of the chassis behind the Craft Management Module (CMM-1) or System Management Module (SMM-1). Isolated outputs allow the primary and redundant supplies to operate in a power-sharing configuration. Should the primary power source fail, a second power supply provides all necessary DC power. AC and DC power supplies should not be installed in the same chassis. CHP Max5000 Management Modules—The CHP Max5000 management modules are available in two models. The Craft Management Module (CMM-1) offers local monitoring and configuration along with a PC compatible graphical user interface (GUI). The System Management Module (SMM-1) offers all the functionality of the CMM-1 plus remote management using SNMP with HMS-compliant MIBs for use with an external element manager or remote access to the CMM-1 interface using an IP connection through the Ethernet interface from the remote GUI software. The CMM-1 and SMM-1 have an auto-configuration feature that allows you to replace an auto-configuration supported application module and the management module automatically restores the configurable parameters of the previously installed module. All management modules offer an RS-232 allowing a computer with Craft Management software to monitor and control modules within that chassis. A chassis with a SMM-1 installed can be daisy-chained with up to nine additional chassis containing a CMM-1 using the RS-485 interface on the rear of the chassis.The CHP Max5000 GUI simplifies system installation, provides monitoring on easy to read screens and displays all critical module information to assist in operational as well as inventory management. Modules currently available Power Supply CHP-PS/AC1-Q or CHP-PS/DC1-Q Isolated power supply accepting 110/220VAC input or accepting –48VDC input. Craft Mgmt. Module CHP-CMM-1 Allows local monitoring and management via laptop computer connected to the RS-232 connector on the front of the CMM. The CHP-CMM-1 adds the auto-configuration feature that allows you to replace an auto-configuration supported application module and the management module automatically restores the configurable parameters of the previously installed module. Craft Mgmt. Software CHP-CMS-1 Software that provides graphical user interface (GUI) and enables local communication for module setup and monitoring of a CHP Max5000 shelf from a portable computer. System Mgmt. Module CHP-SMM-1 Provides all CMM-1 functionality and SNMP port for remote management. SMM-1 also provides remote access to the CMM-1 interface using an IP connection through the Ethernet interface on the back of the shelf from the remote GUI software. The CHP-SMM-1 adds the auto-configuration feature that allows you to replace an auto-configuration supported application module and the management module automatically restores the configurable parameters of the previously installed module.